Alpha Rust Stain Remover (RSR-2000)
An innovative product designed to quickly remove common rust stains from natural stone surfaces or other types of material such as concrete, brick, terra cotta, Mexican tile, or other hard porous surfaces.
This unique product comes as a pre-mixed gel in 14-ounce tubes and is easily applied to rust stained areas. The RSR-2000 is specially formulated to work extremely fast and will immediately begin to work upon contact with rust. In most cases, the RSR-2000 will completely remove a rust stain within 5 minutes or less. Professional contractors, monumentalists, tile contractors, and fabricators will find that the RSR-2000 works much quicker than most poultices and is substantially easier to use. Most poultices tend to be messy and can take a long time to successfully remove stains.
Alpha has designed this highly efficient product as a non-hazardous chemical that is safe to use and will not harm the environment. Since this product is spreadable because of its gel format, large areas can quickly be covered in short amounts of time. A versatile product, RSR-2000 can be used in a variety of areas such as floors, countertops, vertical surfaces and exterior areas. If you have rust stains, RSR-2000 is the best product for you.
IMPORTANT: Follow Instructions and refer to Safety Data Sheet before use.
Since this product’s results are very subjective due to the nature of stone, stain and conditions in which the rust stain remover is applied; it is best to test or perform a demo on a small area or sample piece to check the results produced.
Always wear personal safety equipment when applying and removing Alpha Rust Stain Remover Gel (RSR-2000). Perform your rust stain removal in a well-ventilated area
Instructions:
- Identify the stain type.
- Perform a test by applying a small amount of RSR-2000. If it is a rust stain the RSR-2000 gel will chemically react with the rust stain causing the gel to turn purple in color.
- Remove the purple residue with paper towel then compare your result to the original rust stain. If the results obtained are acceptable, then perform removal over the entire stained area
- Tape around the area that you want to remove the rust stain
- Apply a coat of 1/8″ to 1/4″ thick of RSR-2000 over the rust stained area. Let the RSR-2000 to react with the rust stain for about 10 minutes.
- Remove the purple residue with paper towel.
- Clean the treated area with water.
